Camflite Manuals
Camflite
CRD1
CRD1
  • CRD1 Manual
  • Camflite CRD1 Intro
    • Introduction
    • Getting Started
    • Overview
      • Non-NDAA Controller
      • NDAA Controller
      • RTK GPS Mast Installation
      • Powering
      • Motor Booms
      • Landing Gear
    • Flying
      • Flying Procedures
      • Flight Modes
      • Emergency/Advanced
    • Remote ID
      • How Remote ID works
        • Remote ID indicators in AMC
        • Frequently Asked Questions
        • Serial Number
        • Resgistering with the FAA
    • Software
      • Auterion Mission Control
        • Fly
        • Plan
          • Transfer Mission Plan and KML Files with Herelink
        • Vehicle Setup
        • Photos
        • User Account
        • Settings
          • Advanced
        • Auterion Suite/Flight Logs
    • Network and Connectivity
    • Travel and Shipping
  • Maintenace Manual
    • Periodic Maintenance
    • Motors & Propellers
    • Replacing Components
    • Herelink Controller Maintenance
    • Updating Firmware
    • USB Formating
    • Software Release Notes
    • Calibration and Tuning
    • Troubleshooting
    • Release Notes
  • Payload
    • Flight Operations
      • Pre-Flight Procedures
      • Flying a Mission
      • 3D View
      • Emergency Procedures
      • Operational Limitations
      • Mapping
        • Pre-flight Planning
          • Camera Setup
      • Precise Flight
    • I/O Board and Payload Power
    • Gremsy Gimbal w/Sony A7
    • Resetting Camera Settings
  • Specs and Interfaces
    • Technical Specifications
    • Performance
    • Component Sourcing
  • Ecosystem
    • Batteries
    • Herelink Pilot Controller
    • Payload Isolators
    • GNSS Base Stations
  • Development Tools
    • MavSDK
    • Electrical and I/O
    • Software Interfaces
  • Limited Warranty
  • Service Bullitins
Powered by GitBook
On this page
  • Orange icon: Initialization
  • Green Icon: Healthy
  • Red Icon: Failure
  • Grey Icon: Not enabled or not supported

Was this helpful?

  1. Camflite CRD1 Intro
  2. Remote ID
  3. How Remote ID works

Remote ID indicators in AMC

PreviousHow Remote ID worksNextFrequently Asked Questions

Was this helpful?

Orange icon: Initialization

The orange icon indicates that the Remote ID system is in the initialization state. The Remote ID application on Skynode has not yet received any messages from either APX4 and AMC. If this state persists, there are two likely reasons:

  1. The GCS has no position fix, either because the sensor is missing or disabled, or because the signal quality is not good enough.

  2. APX4 is not communicating with the Remote ID application in AuterionOS. This should only happen during development when the APX4 version is not up to date.

The GCS position can be checked by tapping the Remote ID icon in AMC. If the Lat, Lon and Alt fields are populated, this means that the GCS is good to go and waiting for the drone to finish initialization. An example is shown in the screenshot below:

Green Icon: Healthy

A green icon indicates that the Remote ID system is healthy and the drone is ready to fly.

Red Icon: Failure

The failure state is entered if the Remote ID system was healthy at one point and then encountered an error during operation. One reason might be that Remote ID stopped receiving a heartbeat from either AMC or APX4

Grey Icon: Not enabled or not supported

A grey Remote ID icon in AMC means that Remote ID has either not yet been enabled or the AuterionOS version installed on the vehicle does not have support for it.