Camflite Manuals
Camflite
Aurora
Aurora
  • Aurora Manual
  • Camflite Aurora Intro
    • Introduction
    • Getting Started
    • Overview
      • Non-NDAA Controller
      • NDAA Controller
      • RTK GPS Mast Installation
      • Powering
      • Motor Booms
      • Landing Gear
    • Flying
      • Flying Procedures
      • Flight Modes
      • Emergency/Advanced
    • Remote ID
      • How Remote ID works
        • Remote ID indicators in AMC
        • Frequently Asked Questions
        • Serial Number
        • Resgistering with the FAA
    • Software
      • Auterion Mission Control
        • Fly
        • Plan
          • Transfer Mission Plan and KML Files with Herelink
        • Vehicle Setup
        • Photos
        • User Account
        • Settings
          • Advanced
        • Auterion Suite/Flight Logs
    • Network and Connectivity
    • Travel and Shipping
  • Maintenace Manual
    • Periodic Maintenance
    • Motors & Propellers
    • Replacing Components
    • Herelink Controller Maintenance
    • Updating Firmware
    • USB Formating
    • Software Release Notes
    • Calibration and Tuning
    • Troubleshooting
    • Release Notes
  • Payload
    • Flight Operations
      • Pre-Flight Procedures
      • Flying a Mission
      • 3D View
      • Operational Limitations
      • Mapping
        • Pre-flight Planning
          • Camera Setup
      • Precise Flight
    • I/O Board and Payload Power
    • Gremsy Gimbal w/Sony A7
    • Pro Tips
  • Specs and Interfaces
    • Technical Specifications
    • Performance
    • Component Sourcing
  • Ecosystem
    • Batteries
    • Herelink Pilot Controller
    • Vibration Isolators
    • GNSS Base Stations
  • Development Tools
    • MavSDK
    • Electrical and I/O
    • Software Interfaces
  • Limited Warranty
  • Service Bullitins
Powered by GitBook
On this page
  • Start Mission
  • Pause and Continue Mission

Was this helpful?

  1. Payload
  2. Flight Operations

Flying a Mission

PreviousPre-Flight ProceduresNext3D View

Last updated 1 year ago

Was this helpful?

Auterion Mission Control will automatically prompt you to start, continue or resume a loaded mission, and you can also use the Action button at the bottom of the toolbar to choose any actions that are appropriate for the vehicle state (e.g. to start, pause, or continue a mission). You can also set any waypoint as the current target by selecting it on the map and then using the confirmation slider.

If you have a mission loaded but you want to fly manually, you can cancel the prompts and get them back later using the Action button. To stop the prompts altogether you will need to clear the mission from the vehicle (use Plan View > File/Sync tools to clear the mission).

Start Mission

The drone will arm, take off and start the mission without you doing anything else. It is that easy! You can monitor the progress on the map and use the telemetry instrumentation provided.

Pause and Continue Mission

Pause a mission by selecting the Pause button on the toolbar and then using the slider on the confirmation prompt. The altitude at which the vehicle should wait when paused may be set using the vertical slider on the right-hand side of the screen.

Mission Control will prompt you to continue the mission after pausing (or if you take off with a mission loaded). If the dialog is closed, you can get it back and continue the mission using the Action button on the toolbar.

For more details on flying missions, please

Click Here