Camflite Manuals
Camflite
Aurora
Aurora
  • Aurora Manual
  • Camflite Aurora Intro
    • Introduction
    • Getting Started
    • Overview
      • Non-NDAA Controller
      • NDAA Controller
      • RTK GPS Mast Installation
      • Powering
      • Motor Booms
      • Landing Gear
    • Flying
      • Flying Procedures
      • Flight Modes
      • Emergency/Advanced
    • Remote ID
      • How Remote ID works
        • Remote ID indicators in AMC
        • Frequently Asked Questions
        • Serial Number
        • Resgistering with the FAA
    • Software
      • Auterion Mission Control
        • Fly
        • Plan
          • Transfer Mission Plan and KML Files with Herelink
        • Vehicle Setup
        • Photos
        • User Account
        • Settings
          • Advanced
        • Auterion Suite/Flight Logs
    • Network and Connectivity
    • Travel and Shipping
  • Maintenace Manual
    • Periodic Maintenance
    • Motors & Propellers
    • Replacing Components
    • Herelink Controller Maintenance
    • Updating Firmware
    • USB Formating
    • Software Release Notes
    • Calibration and Tuning
    • Troubleshooting
    • Release Notes
  • Payload
    • Flight Operations
      • Pre-Flight Procedures
      • Flying a Mission
      • 3D View
      • Operational Limitations
      • Mapping
        • Pre-flight Planning
          • Camera Setup
      • Precise Flight
    • I/O Board and Payload Power
    • Gremsy Gimbal w/Sony A7
    • Pro Tips
  • Specs and Interfaces
    • Technical Specifications
    • Performance
    • Component Sourcing
  • Ecosystem
    • Batteries
    • Herelink Pilot Controller
    • Vibration Isolators
    • GNSS Base Stations
  • Development Tools
    • MavSDK
    • Electrical and I/O
    • Software Interfaces
  • Limited Warranty
  • Service Bullitins
Powered by GitBook
On this page

Was this helpful?

  1. Maintenace Manual

Herelink Controller Maintenance

Here is some maintenance information about how Camflite has implemented the Herelink into Aurora.

PreviousReplacing ComponentsNextUpdating Firmware

Last updated 1 year ago

Was this helpful?

It's important to note that Herelink can be purchased from various sources, but we recommend the Aurora version for optimal performance and functionality. It's best to avoid using any ports on the Herelink Air Unit to maintain its optimizations and prevent any potential disabling. Although the Herelink wiki can be helpful in certain situations, its accuracy may not always be applicable to Aurora. Feel free to reach out to us with any questions or concerns through our website's "Contact Us" page or contact@camflite.com.

Herelink Binding

Prepare non-metallic tweezers or toothpicks.

Remove the Herelink cover.

Install both batteries on Aurora and activate it.

Turn on the Herelink Pilot Handset.

Use your finger to pull down from the top of the screen and select the Herelink Radio Status message.

On the Herelink Radio page, tap “Pair”.

To pair or reset the Herelink Air Unit, simply use tweezers to press and hold the "Pair/Reset" button until LED2 starts blinking. This usually takes around 3 seconds.

Verify the Herelink Pilot Handset shows a status of "PAIRED" and that the uplink rate is non-zero.

Open the AMC app on Herelink Pilot Handset and verify the connection to the aircraft. Power off Aurora and Herelink Pilot Handset.

Reinstall the Herelink cover.