Camflite Manuals
Camflite
Aurora
Aurora
  • Aurora Manual
  • Camflite Aurora Intro
    • Introduction
    • Getting Started
    • Overview
      • Non-NDAA Controller
      • NDAA Controller
      • RTK GPS Mast Installation
      • Powering
      • Motor Booms
      • Landing Gear
    • Flying
      • Flying Procedures
      • Flight Modes
      • Emergency/Advanced
    • Remote ID
      • How Remote ID works
        • Remote ID indicators in AMC
        • Frequently Asked Questions
        • Serial Number
        • Resgistering with the FAA
    • Software
      • Auterion Mission Control
        • Fly
        • Plan
          • Transfer Mission Plan and KML Files with Herelink
        • Vehicle Setup
        • Photos
        • User Account
        • Settings
          • Advanced
        • Auterion Suite/Flight Logs
    • Network and Connectivity
    • Travel and Shipping
  • Maintenace Manual
    • Periodic Maintenance
    • Motors & Propellers
    • Replacing Components
    • Herelink Controller Maintenance
    • Updating Firmware
    • USB Formating
    • Software Release Notes
    • Calibration and Tuning
    • Troubleshooting
    • Release Notes
  • Payload
    • Flight Operations
      • Pre-Flight Procedures
      • Flying a Mission
      • 3D View
      • Operational Limitations
      • Mapping
        • Pre-flight Planning
          • Camera Setup
      • Precise Flight
    • I/O Board and Payload Power
    • Gremsy Gimbal w/Sony A7
    • Pro Tips
  • Specs and Interfaces
    • Technical Specifications
    • Performance
    • Component Sourcing
  • Ecosystem
    • Batteries
    • Herelink Pilot Controller
    • Vibration Isolators
    • GNSS Base Stations
  • Development Tools
    • MavSDK
    • Electrical and I/O
    • Software Interfaces
  • Limited Warranty
  • Service Bullitins
Powered by GitBook
On this page
  • How does Skynode broadcast the Remote ID?
  • Can Skynode's WiFi still be used alongside Remote ID?
  • Can Remote ID be disabled on Skynode?

Was this helpful?

  1. Camflite Aurora Intro
  2. Remote ID
  3. How Remote ID works

Frequently Asked Questions

PreviousRemote ID indicators in AMCNextSerial Number

Last updated 1 year ago

Was this helpful?

How does Skynode broadcast the Remote ID?

Skynode is currently using WiFi beacon frames to broadcast the Remote ID Data. More details can be found on the page How .

Can Skynode's WiFi still be used alongside Remote ID?

Currently, it is not possible to use regular WiFi while Remote ID is enabled since Auterion then cannot guarantee that the message interval is strictly lower than 1s at all times.

Can Remote ID be disabled on Skynode?

Only developers and manufacturers can temporarily disable Remote ID.

References Provided by Auterion

Remote ID works