Camflite Manuals
Camflite
CRD1
CRD1
  • CRD1 Manual
  • Camflite CRD1 Intro
    • Introduction
    • Getting Started
    • Overview
      • Non-NDAA Controller
      • NDAA Controller
      • RTK GPS Mast Installation
      • Powering
      • Motor Booms
      • Landing Gear
    • Flying
      • Flying Procedures
      • Flight Modes
      • Emergency/Advanced
    • Remote ID
      • How Remote ID works
        • Remote ID indicators in AMC
        • Frequently Asked Questions
        • Serial Number
        • Resgistering with the FAA
    • Software
      • Auterion Mission Control
        • Fly
        • Plan
          • Transfer Mission Plan and KML Files with Herelink
        • Vehicle Setup
        • Photos
        • User Account
        • Settings
          • Advanced
        • Auterion Suite/Flight Logs
    • Network and Connectivity
    • Travel and Shipping
  • Maintenace Manual
    • Periodic Maintenance
    • Motors & Propellers
    • Replacing Components
    • Herelink Controller Maintenance
    • Updating Firmware
    • USB Formating
    • Software Release Notes
    • Calibration and Tuning
    • Troubleshooting
    • Release Notes
  • Payload
    • Flight Operations
      • Pre-Flight Procedures
      • Flying a Mission
      • 3D View
      • Emergency Procedures
      • Operational Limitations
      • Mapping
        • Pre-flight Planning
          • Camera Setup
      • Precise Flight
    • I/O Board and Payload Power
    • Gremsy Gimbal w/Sony A7
    • Resetting Camera Settings
  • Specs and Interfaces
    • Technical Specifications
    • Performance
    • Component Sourcing
  • Ecosystem
    • Batteries
    • Herelink Pilot Controller
    • Payload Isolators
    • GNSS Base Stations
  • Development Tools
    • MavSDK
    • Electrical and I/O
    • Software Interfaces
  • Limited Warranty
  • Service Bullitins
Powered by GitBook
On this page
  • 1. Unboxing the CRD1
  • 2. Connecting your CRD1 to the Internet

Was this helpful?

  1. Camflite CRD1 Intro

Getting Started

PreviousIntroductionNextOverview

Last updated 8 months ago

Was this helpful?

1. Unboxing the CRD1

It's crucial to push down the boom lock all the way to ensure the booms don't open during the flight, which could lead to a crash. So, make sure to double-check the lock before flying!

2. Connecting your CRD1 to the Internet

Connecting the CRD1 to the internet allows you to connect to the Auterion Suite, load maps, download software updates, and communicate with your drone.

Connect your aircraft to a wifi network to ensure your drone is always connected to the Suite after a day of flying. To connect your CRD1 to the wifi:

  1. Open AMC Herelink or PC. If using a PC, connect to CRD1 with a USB-C cable.

  2. Power CRD1.

  3. Tap the icon in the top-left of AMC. Navigate to Vehicle Setup > WiFi

  4. Select Station mode, which allows CRD1 to connect to another wifi network.

  5. Enter the login credentials for your wifi access point.

  6. Remote ID will need to have the WIFI disabled.